Striker Retainer Pin Installation

DSC_5778.jpg
DSC_5778.jpg

Striker Retainer Pin Installation

5.00
Quantity:
Add To Cart

Striker Retainer Pin

The factory striker retainer pin can be located on the top of the slide as seen in the picture above by the red arrow. The factory part is a 3mm x 16mm carbon steel split roll pin. The same pin is found in all XD and XDM pistol slides and is considered a consumable part that should be replaced every couple thousand rounds or with prolonged dry-firing. Springfield Armory receomends use of snap caps to extend the life of the part during dry-firing sessions. If you notice that this roll pin keeps working it's way out of the slide it should probably be replaced.

Brand new virgin pins that have never been installed into a pistol before can be harder to install into the slide. For 5.00 we will install your roll pin. We will disassemble the slide and install the new retainer pin. If we can get your facotry one out without damage we will return your facotry parts. With this service you can either purchace the Retainer Pin direct from us or send your own with your slide. If you need a roll pin we sell them in the parts section.